Note: This error occurs due to incorrect DipSW setting of the MCT board or heater control failure caused by electrical malfunction, etc. The plate temperature is low. Incorrect DipSW setting of the MCT board, connector malfunction, malfunction of the temperature detection thermistor, disconnection of the heaters, disconnection of the cable between the heater and power supply unit, reset of heater by thermal protector, or malfunction of heater port of the MCT board. Check that the DipSW settings of the MCT board are correct, the heater connector and cable to the heater, and connectors of the power supply unit and MCT board are set correctly.
|Published (Last):||8 November 2019|
|PDF File Size:||8.90 Mb|
|ePub File Size:||17.19 Mb|
|Price:||Free* [*Free Regsitration Required]|
Some other benefits include: less maintenance costs - such as darkroom ventilation, chemical storage, and additional plumbing, electricity, and drainage. Also, dry processing laser printing systems can be strategically placed almost anywhere in a facility because of their compact nature.
A dry processing laser imaging system may be a cost-effective solution for a facility that is upgrading or purchasing new equipment. Facilities that are already using wet processing equipment usually stick with it; the film is well produced, the conversion from one system to another can be too costly, and the radiologists are comfortable with the stability of developing by wet processing systems.
All laser printers should be able to record about 4, shades of gray. In nuclear medicine departments, the dry small format laser imager is most commonly used. Facilities must first determine the necessary throughput of the system based on the current patient load.
Dry small format laser imagers, used specifically for NM and ultrasound, average the same throughput as low throughput imagers. For all laser imagers, local hard-drive storage is recommended. In order to accommodate various images, imagers should have multiple formats. Users need to follow calibration procedures recommended by the manufacturer for acceptable long-term performance.
All units should offer remote diagnostics. The purpose of this standard is that several devices meeting the standard could be organized into a system that communicates without customized interfaces.
fuji drypix 4000 or 7000 IP ADDRESS
Fuji Drypix 7000 Dry Laser Imager for Hospital