Vushicage Email to friends Share on Facebook — opens in a new window or tab Share on Twitter — tdaa in a new window or tab Share on Pinterest — opens in tdaa new window or tab. Credit Cards processed by PayPal. General terms and conditions. Distributor Name Region Stock Min. Special tdaa available Tdaa PayPal Credit at checkout to have tdaa option to pay over time. Add to watch list.
|Country:||Sao Tome and Principe|
|Published (Last):||17 March 2005|
|PDF File Size:||9.42 Mb|
|ePub File Size:||20.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
Table 1. Table 2. Table 3. Table 4. Table 5. Device summary. Figure 2. Figure 3. Figure 4. Figure 5. Figure 6. Figure 7. Figure 8. Figure 9. Figure Block diagram. Standard test and application circuit C8 0. Parameter Test Condition Min. Saturated square wave output. Electrical characteristic curves Quiescent current vs.
Output power vs. Distortion vs. Crosstalk vs. Supply voltage rejection vs. Output attenuation vs. Power dissipation vs. To conveniently serve both needs, Its minimum recommended value is 10? If the standard value for the input capacitors 0. F is adopted, the low frequency cut-off will amount to 16 Hz. R-C cells have always to be used in order to smooth down the transitions for preventing any audible transient noises. About the stand-by, the time constant to be assigned in order to obtain a virtually pop-free transition has to be slower than 2.
The feature works with the amplifier unmuted and no signal at the inputs. The DC offset detection can be available at 2 different pins: — — Pin 2 always enabled Pin Only enabled if Vmute pin23 is set higher than 8V.
Noise with gaussian-distributed amplitude was employed for this simulation. This would avoid any thermal shutdown occurrence even after long-term and full-volume operation. These packages have a Lead-free second level interconnect. The maximum ratings related to soldering conditions are also marked on the inner box label. Flexiwatt27 vertical mechanical data and package dimensions DIM. Flexiwatt27 horizontal mechanical data and package dimensions DIM.
Date 9-Oct Document revision history Revision 1 Initial release. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document.
If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein.
Information in this document supersedes and replaces all information previously supplied. All other names are the property of their respective owners.